AUSTRALIAN MONITOR AMHEAVYG Інструкція з експлуатації - Сторінка 2
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Мікрофон AUSTRALIAN MONITOR AMHEAVYG. AUSTRALIAN MONITOR AMHEAVYG 2 сторінки. Heavy-duty gooseneck microphone
Також для AUSTRALIAN MONITOR AMHEAVYG: Інструкція з експлуатації (4 сторінок)
Друкувати сторінкуINSTALLING YOUR AMHEAVYG MICROPHONE
Installing your microphone
1 Choose a suitable flat surface to install the microphone.
2 Using a drill or spade bit drill a 5mm hole in the surface to run the cable through.
3 Using a maker or punch, mark the position of the three holes in the microphone base.
4 Using suitable fasteners secure the microphone in place.
Wiring your microphone
The AMHEAVYG is shipped with an unterminated 5 wire cable. This allows the installer to customise
the connection type between the AMHEAVYG and device input.
The AM HEAVY provides a balanced microphone output signal. It also provides a normally open
(N/O) dry contact closure output from the momentary switch allowing connection to third party
devices such as a pre-announce tone generator.
Please follow the table below for successful wiring and operation of your microphone.
Audio Wiring Termination
Red wire
Audio Positive (+)
Black wire
Audio Negative (-)
Drain / Shield Audio Ground
Base Plate
Dimensions
Switch Wiring Termination
Green wire
Switch
White wire
Switch
(Normally Open N/O)
Typical Polar
Patterns
Typical Frequency
Response
15mm
70mm
Specifications