- ページ 2
ロボット工学 4tronix Pan ServoのPDF マニュアルをオンラインで閲覧またはダウンロードできます。4tronix Pan Servo 7 ページ。 Pan & tilt kit for pi2go and pi2go-lite
ページを印刷する2 x Tower Pro SG92R carbon fibre micro servos
•
4 x M3 Self tapping 6mm screws (for attaching servo arms)
•
4 x M2.5 screws 6mm (for mounting the servos)
•
4 x M1.7 self-tapping screws 5mm (black, for mounting camera)
•
2 x M3 male-female pillars 12mm
•
1 x 200mm camera cable
•
Step 2: Solder the Camera Mount to a Servo Arm Plate
Push the camera mount plate, with the camera markings on the inside as shown, into
•
one of the servo arm plates
Tack solder in one place
•
Adjust the fitting until the camera mount is at right angles to the arm plate
•
Solder all the other places on both sides for maximum strength (in fact there is very
•
little weight, so only a couple of points need soldering if you're in a hurry!)