- ページ 3

ロボット工学 4tronix Ultimate Initio kitのPDF マニュアルをオンラインで閲覧またはダウンロードできます。4tronix Ultimate Initio kit 11 ページ。 For raspberry pi

It won't damage it if you connect them differently, but the example programs won't go the

direction that you would expect

Plug the Black/White cable with the DC Jack into the left-most pins on the switch PCB on

Initio and the DC Jack end into the Pirocon as shown above.

Check all the wiring again very carefully, then now is a good time to see if the Pi powers up

and you can control the motors.

Use 6xAA batteries. These should be good quality rechargeable batteries. We recommend

Energizer Extremes or Eneloops

Connect a monitor, keyboard and mouse to the Raspberry Pi, plug in your SD card and switch

on. The green light near the On/Off switch should turn on, the LEDs on the Pi should start

flashing and the booting sequence should appear on the monitor. If not, switch off and double

check the wiring.

Instead of using the batteries, you can plug a micro-USB cable directly into the connector on

the Pi. This is an excellent way to get started and allows you to test everything (except the

motors, which may turn but only slowly) without using batteries.