ページを印刷する
OPERATION
OPERATION
HOW TO SET THE PRESENT TIME
1.
Press the SET button for five seconds. The
time indication alone flashes.
2. Press the + or - buttons until the present time
is displayed.
3. Press the SET button to stop the indication
flashing.
COOLING
Verify that the unit is connected
to the main power and the
STANDBY lamp is light up.
1. Set the MODE selector to
COOL
.
2. Press the ON/OFF button
and switch the airconditioner
ON.
3. Press the TEMP. buttons to
set the desired temperature
(the temperature range is
between 30°C max. and 16°
C min.).
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE.
4. Press the FAN SPEED button to select the fan
speed.
5. Press the FLAP buttons and adjust the air
flow direction as desired(see adjustment of
air flow). Make sure that the remote control is
switched on.
HEATING
1. Set the MODE selector to HEAT
2. Press the ON/OFF button and switch the air
condioner ON.
3. Press the TEMP. buttons to set the desired
temperature (the temperature range is
between 30 °C max. and 16 °C min.).
THE DISPLAY SHOWS THE
SELECTED TEMPERATURE.
4. Press the FAN SPEED button to select the fan
speed.
5. Press the FLAP buttons and adjust the air
flow direction as desired(see adjustment of
air flow). Make sure that the remote control is
switched on.
NOTE
For several minutes after the start of heating
operation, the indoor fan will not run until the
indoor heat exchanger coil has warmed up
sufficiently. This is because the COLD DRAFT
PREVENTION SYSTEM is operating.
DEFROSTING OF HEAT EXCHANGE OUT
DOOR UNIT "STANDBY"
When the outdoor temperature is low, frost or
ice may appear on the heat exchanger coil,
reducing the heating performance. When this
happens, a microcomputer defrosting system
operates. At the same time, the fan in the indoor
unit stops and the OPERATION lamp is flashing
until defrosting is completed. Heating operation
restarts after several minutes. (This interval will
vary slightly depending on the room and outdoor
temperature).
HEATING PERFORMANCE
A heat pump conditioner heats a room by taking
heat from outside air. The heating efficiency will
fall off when the outdoor temperature is very
low. If enough heat is not obtained with this air
conditioner, use another heating appliance in
conjunction with it.
.
4