Airwell RC7 사용 설명서 - 페이지 5

{카테고리_이름} Airwell RC7에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Airwell RC7 10 페이지.

페이지 인쇄

OPERATION

HOW TO SET THE PRESENT TIME

Press the SET button for five seconds. The

time indication alone flashes.

2. Press the + or - buttons until the present time

is displayed.

3. Press the SET button to stop the indication

flashing.

COOLING

Verify that the unit is connected

to the main power and the

STANDBY lamp is light up.

1. Set the MODE selector to

COOL

2. Press the ON/OFF button

and switch the airconditioner

ON.

3. Press the TEMP. buttons to

set the desired temperature

(the temperature range is

between 30°C max. and 16°

C min.).

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE.

4. Press the FAN SPEED button to select the fan

speed.

5. Press the FLAP buttons and adjust the air

flow direction as desired(see adjustment of

air flow). Make sure that the remote control is

switched on.

HEATING

1. Set the MODE selector to HEAT

2. Press the ON/OFF button and switch the air

condioner ON.

3. Press the TEMP. buttons to set the desired

temperature (the temperature range is

between 30 °C max. and 16 °C min.).

THE DISPLAY SHOWS THE

SELECTED TEMPERATURE.

4. Press the FAN SPEED button to select the fan

speed.

5. Press the FLAP buttons and adjust the air

flow direction as desired(see adjustment of

air flow). Make sure that the remote control is

switched on.

NOTE

For several minutes after the start of heating

operation, the indoor fan will not run until the

indoor heat exchanger coil has warmed up

sufficiently. This is because the COLD DRAFT

PREVENTION SYSTEM is operating.

DEFROSTING OF HEAT EXCHANGE OUT

DOOR UNIT "STANDBY"

When the outdoor temperature is low, frost or

ice may appear on the heat exchanger coil,

reducing the heating performance. When this

happens, a microcomputer defrosting system

operates. At the same time, the fan in the indoor

unit stops and the OPERATION lamp is flashing

until defrosting is completed. Heating operation

restarts after several minutes. (This interval will

vary slightly depending on the room and outdoor

temperature).

HEATING PERFORMANCE

A heat pump conditioner heats a room by taking

heat from outside air. The heating efficiency will

fall off when the outdoor temperature is very

low. If enough heat is not obtained with this air

conditioner, use another heating appliance in

conjunction with it.