- ページ 8

産業機器 dymax BlueWave MX-150のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dymax BlueWave MX-150 16 ページ。 Ledd spot-curing emitters
dymax BlueWave MX-150 にも：ユーザーマニュアル (12 ページ)

ページを印刷する

1. Troubleshooting & Maintenance

BlueWave® MX-150 Emitter User Guide

Troubleshooting & Maintenance

Problem

BlueWave® MX-150

LED does not

produce light

BlueWave® MX-150

LED suddenly stops

producing light

BlueWave® MX-150

LED provides only

low-intensity light

Possible Cause

LED intensity adjustment

set to 0% or too low

LED cycle time is set to 0

seconds

Interlock is open

Interface cable connections

loose or damaged

Trigger setting not

matched to input

LED head is not connected

to the correct port/channel

Lightguide not inserted

Over-temperature

shutdown was triggered

Footswitch defective

Interlock is open

LED intensity adjustment

set to minimum

Contaminated/dirty lens

optics

Corrective Action

Increase LED intensity setting.

0 Seconds sets manual mode and

requires a trigger.

Verify interlock jumpers are in place.

Verify PLC command structure for PLC

mode.

Check connections and condition of

interface cable.

Trigger setting on admin screen should

match the desired input trigger

channel.

Verify that the head is connected to the

desired port/channel.

Ensure the lightguide simulator or any

lightguides installed with the unit are

fully seated into the Wolf connector.

Verify alarms.

Activate unit using the front control

panel. Replace the footswitch if the unit

operates from the front control panel.

Verify interlock jumpers are in place.

Verify PLC command structure for PLC

mode.

Increase LED intensity setting on admin

settings or I/O input for PLC mode.

Clean the surface of the lens.