- ページ 12
産業機器 dymax T17240のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。dymax T17240 20 ページ。 Digital syringe dispenser
ページを印刷する
12
SD-100 Digital Syringe Dispenser User Guide
Operating the System
Operation
Manual Mode
Manual mode allows the user to dispense for an unlimited amount of time by either
pressing down on the supplied foot pedal or pushing the SHOT button on the front of
the SD-100 unit. The material will continue to dispense for as long as the user is pushing
down on the foot pedal or pressing the SHOT button. As soon as either of these are
released, the dispensing will stop.
The unit will also count the amount of time you are dispensing during a cycle which may
be helpful in determining a time to be used when programming the timer mode. If you
need to adjust the decimal point to allow for the timer to show a higher or smaller
value, press the SET button then use the ▲ and ▼ to adjust the position.
1.
Press the MODE button to cycle to Manual Mode.
2.
Press the SHOT button or the foot pedal to start dispense. Release either to stop
dispense.
Timer Mode
The Timer Mode allows the user to dispense for a set period of time despite how long
the foot pedal is pressed.
For example: If you would like to set the dispenser to dispense for 1 second, follow the
instructions below.
1.
Press the MODE button until the timer mode is selected.
2.
Press the SET button. The first digit on the right side of the display will start
blinking.
3.
Press the ◄ button twice. The third digit from the right on the digital display
should be blinking.
Press the ▲ button once to increase the value of this digit. To adjust the decimal
4.
refer to page 15.
5.
Press Exit/Mode to save as current setting.