- ページ 9

ラック＆スタンド GABOR ACCUGEAR UPMP-1000のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GABOR ACCUGEAR UPMP-1000 16 ページ。 Universal projector mount

If your projector model has only three holes for mounting, then remove the

fourth arm with the hex key (I).

Warning! Do not use the projector mount with only two arms.

3. Slide the arms around the projector

mount and along the arm's shaft to

position them over your projector's

mounting holes. Make sure the notch

on the mount is as close to the

center of gravity for your projector

as possible.

4. Use the hex key (I) and the screws

from step 1 to secure the mount to

the projector, and tighten the arms

until secure.

5. Once the projector mount is attached to your projector, adjust the feet of the

arms vertically to level the mount.

Loosen

Adjust

Tighten