- ページ 11
ラック＆スタンド GABOR FSM-SのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GABOR FSM-S 16 ページ。 Mount for small flat-panel displays
ページを印刷する
Attaching the Wall Bracket to Concrete
Warning! Make sure the concrete wall is solid and at least 8 inches (20 cm) thick.
If the concrete exhibits cracks or other defects, this may result in failure of the
concrete anchors and cause serious personal injury or damage to your display.
X
X
X
X
1.
Place the wall bracket template up to the
marked locations and tape it to the wall.
Use the included bubble level to make
sure the template is level before drilling.
Use a pencil to mark the four drilling
holes for the anchor screws and then
apply a piece of tape over the marks.
3/8 in.
2.4 in.
2.
Use a 3/8-inch (10 mm) concrete drill bit
to predrill the marked spots 2.4 inches
(60 mm) deep, and then clean out the
debris from the holes.
H
I
J
K
L
N
O
4X
4X
4X
1X
2X
1X
1X
3.
Remove the template, insert the
concrete anchors into the predrilled
holes, and use a hammer to tap the
anchors into the concrete.
11