GABOR FSM-S 사용자 설명서 - 페이지 11

{카테고리_이름} GABOR FSM-S에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GABOR FSM-S 16 페이지. Mount for small flat-panel displays

Attaching the Wall Bracket to Concrete

Warning! Make sure the concrete wall is solid and at least 8 inches (20 cm) thick.

If the concrete exhibits cracks or other defects, this may result in failure of the

concrete anchors and cause serious personal injury or damage to your display.

Place the wall bracket template up to the

marked locations and tape it to the wall.

Use the included bubble level to make

sure the template is level before drilling.

Use a pencil to mark the four drilling

holes for the anchor screws and then

apply a piece of tape over the marks.

3/8 in.

2.4 in.

Use a 3/8-inch (10 mm) concrete drill bit

to predrill the marked spots 2.4 inches

(60 mm) deep, and then clean out the

debris from the holes.

Remove the template, insert the

concrete anchors into the predrilled

holes, and use a hammer to tap the

anchors into the concrete.