- ページ 5

ラベルメーカー Dymo Rhino 1011 Metal Tape EmbosserのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Dymo Rhino 1011 Metal Tape Embosser 14 ページ。 Metal tape embosser

Cutting the Tape

To cut the tape

1. Squeeze the embossing handle half-way, several times until the

tape extends from the front of the cutting assembly (M) by at least

1 cm (1").

Before cutting the tape, make sure the end of the tape

extends beyond the edge of the cutting assembly so you can easily

pull the label out. Otherwise, a tape jam may occur.

2. Lift the cutting handle (I) gently until it is vertical to cut the tape.