ページを印刷するPRODUCT DESCRIPTION
SPEAKERS
SPEAKERS
R+R-
L-L+
L
PHONO
LINE
R
USB-PC
DC IN 15V
11. 33 1/3 / 45 Speed Button
1. Lid Hinge
12. Indicator
2. Stepped Drive Pulley
13. Volume Control
3. Drive Belt
14. Tonearm Clip
4. Turntable Spindle
15. Tonearm Lift Lever
5. Turntable Hub
16. Tonearm Lift
6. Turntable Platter
17. Anti-skating weight
7. Dust Cover
18. Tonearm Counterweight
8. Cartridge
19. Ground Connector
9. Function Switch Button
20. R Jack for RCA Line out
10. PLAY / STOP Button
MODE
33
PLAY
45
ON
OFF
21. L Jack for RCA Line out
22. Phono / Line Out Switch
23. USB Port
24. Power Jack
25. Power Amplifier R+
26. Power Amplifier R-
27. Power Amplifier L+
28. Power Amplifier L-
29. Power Switch
30. Speaker Jack -
31. Speaker Jack +
12
GETTING STARTED
INITIAL SETUP
1. Place the unit on a flat and level surface. The selected location should
be stable and free from vibration.
2. Install the turntable lid to the hinges.
3. Remove the tie-wrap that is holding the tonearm.
4. Put the drive belt around the Turntable Hub, and then use the provided
belt hoot to help pull the belt to fit around the slot of motor pulley.
5. Place the turntable platter through the turntable spindle.
6. Place the slip mat on top of the turntable platter.
7. Slide Tonearm Counterweight onto tonearm and twist it lightly onto the
rear shaft of the tonearm.
8. Adjust the counterweight to set proper stylus pressure.
9. Connect the adaptor to the Power Jack of the unit.
NOTE: Do not plug the AC power adaptor to power outlet before all the
assembly is completed. Before turning the power on, make sure again all
the connection setting are correct. Always turn off the power when
connecting or disconnecting.
CARTRIDGE DOWN FORCE ADJUSTMENT
The Counterweight supplied is suitable for cartridges weighing between
3.0-6.0g. Gently push and turn the Counterweight onto the rear of the
tonearm (with the scale facing toward the front of the turntable).
Remove the cartridge protection cap. Lower the tonearm lift and position
the cartridge in the space between tonearm rest and platter.Carefully
rotate the Counterweight until the tonearm balances out. The tonearm
should return to the balanced position if it is moved up or down.
This adjustment must be done carefully.
Counterweight
Downforce scale ring
Center line
13