- ページ 6

ツール Gage Bilt GB730のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Gage Bilt GB730 13 ページ。 Installation tool
Gage Bilt GB730 にも：インストレーション・マニュアル (14 ページ)

ページを印刷する

DESCRIPTION

WARNING:

The balance of this tool is designed for horizontal use and is not ergonomically best

suited for all applications. Gage Bilt will be pleased to advise for your specific

application.

The GB730 is a pneumatic-hydraulic tool designed specifically for the efficient installation of a wide range of

blind rivets and lockbolts. It weighs 5 lbs. and can be operated in any position with one hand. It has a .500"

rivet setting stroke and a rated pull load of 4000 pounds with 90 psi air pressure at the air inlet.

The GB730 riveter operates on a wide range of air pressure, with 90 to 100 psi providing the maximum

efficiency. At 90 psi. air pressure, the GB730 does not exceed 81.5 db (A) and consumes 3.9 cfm at 20 cycles

per minute.

The air inlet is provided with 1/4-18 female pipe threads for accepting the user's air hose fitting.

Nose Assemblies that were designed for the Model 352 Installation Tool mount directly on the GB730 without

the use of an adapter.

MAINTENANCE

WARNING:

Excessive contact with hydraulic fluid and lubricants should be avoided.

WARNING:

Maintenance personnel

The performance of any tool depends upon good maintenance practices. Following these minimal

requirements for service and care will extend the life of your tool.

*Only use an air supply set at 90-100 psi. equipped with a filter-regulator to prevent wear.

*The tool will eventually lose some hydraulic oil. Keep the hydraulic system full (only use Dexron III, or

equivalent) and free of air by using the air bleeder (745163) on a regular basis.

*Proper care by operator is necessary in maintaining full productivity and reducing downtime. Read all

applicable tool manuals and nose assembly data sheets prior to operating tools.

*Keep nose assemblies, especially jaws, clean and free of chips and debris.

*All Screwed End Caps, Base Covers, Air Fittings, Triggers, Screws and Nose Assemblies are to be examined at

the end of each working shift to check that they are secure.

*Check daily all Hoses, Couplings, and Tools for damage or air/hydraulic leaks. Tighten or replace (if necessary).

*For a complete overhaul, tool kit GB730TK is recommended.

TORQUE SPECIFICATIONS

Button Head Cap Screws (A-928) = 40 inch lbs.

Packing Plug (704118) = 45 foot lbs.

Flexlock Nut (400559) = 40 inch lbs.

WARNING:

This tool incorporates a patented hydraulic relief valve. When overhauling tool, o'ring

(S829), back-up ring (401084), retaining ring (400935) and spring (50806) must be

replaced. Failure to do so could result in SEVERE PERSONAL INJURY!

MUST

O'RING - S829

BACK - UP RING - 401084

SPRING - 50806

RETAINING RING - 400935

read and understand all warnings and cautions.

PISTON ROD ASSY. - 730233

Covered under Patent No. 5,485,727

Rev. 9/11