Gage Bilt GB730 사용자 설명서 - 페이지 6
{카테고리_이름} Gage Bilt GB730에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Gage Bilt GB730 13 페이지. Installation tool
Gage Bilt GB730에 대해서도 마찬가지입니다: 설치 매뉴얼 (14 페이지)
페이지 인쇄
DESCRIPTION
WARNING:
The balance of this tool is designed for horizontal use and is not ergonomically best
suited for all applications. Gage Bilt will be pleased to advise for your specific
application.
The GB730 is a pneumatic-hydraulic tool designed specifically for the efficient installation of a wide range of
blind rivets and lockbolts. It weighs 5 lbs. and can be operated in any position with one hand. It has a .500"
rivet setting stroke and a rated pull load of 4000 pounds with 90 psi air pressure at the air inlet.
The GB730 riveter operates on a wide range of air pressure, with 90 to 100 psi providing the maximum
efficiency. At 90 psi. air pressure, the GB730 does not exceed 81.5 db (A) and consumes 3.9 cfm at 20 cycles
per minute.
The air inlet is provided with 1/4-18 female pipe threads for accepting the user's air hose fitting.
Nose Assemblies that were designed for the Model 352 Installation Tool mount directly on the GB730 without
the use of an adapter.
MAINTENANCE
WARNING:
Excessive contact with hydraulic fluid and lubricants should be avoided.
WARNING:
Maintenance personnel
The performance of any tool depends upon good maintenance practices. Following these minimal
requirements for service and care will extend the life of your tool.
*Only use an air supply set at 90-100 psi. equipped with a filter-regulator to prevent wear.
*The tool will eventually lose some hydraulic oil. Keep the hydraulic system full (only use Dexron III, or
equivalent) and free of air by using the air bleeder (745163) on a regular basis.
*Proper care by operator is necessary in maintaining full productivity and reducing downtime. Read all
applicable tool manuals and nose assembly data sheets prior to operating tools.
*Keep nose assemblies, especially jaws, clean and free of chips and debris.
*All Screwed End Caps, Base Covers, Air Fittings, Triggers, Screws and Nose Assemblies are to be examined at
the end of each working shift to check that they are secure.
*Check daily all Hoses, Couplings, and Tools for damage or air/hydraulic leaks. Tighten or replace (if necessary).
*For a complete overhaul, tool kit GB730TK is recommended.
TORQUE SPECIFICATIONS
Button Head Cap Screws (A-928) = 40 inch lbs.
Packing Plug (704118) = 45 foot lbs.
Flexlock Nut (400559) = 40 inch lbs.
WARNING:
This tool incorporates a patented hydraulic relief valve. When overhauling tool, o'ring
(S829), back-up ring (401084), retaining ring (400935) and spring (50806) must be
replaced. Failure to do so could result in SEVERE PERSONAL INJURY!
MUST
O'RING - S829
BACK - UP RING - 401084
SPRING - 50806
RETAINING RING - 400935
read and understand all warnings and cautions.
PISTON ROD ASSY. - 730233
6
Covered under Patent No. 5,485,727
Rev. 9/11