セキュリティシステム 2gig Technologies Go ControlのPDF クイックマニュアルをオンラインで閲覧またはダウンロードできます。2gig Technologies Go Control 1 ページ。 Panel keypad

2GIG Go Control Keypad
2GIG Home Screen
2GIG Main SECURITY Menu
2GIG Arming Screen
2GIG PANEL
KEYPAD QUICKGUIDE
– All protected windows and doors must be closed. Ready light should
Arm System
be green.
 Away— From Home Screen- Press SECURITY button, Press ARM button, Press AWAY
Arms all devices including motion detectors.
 Stay— From Home Screen- Press SECURITY button, Press ARM button, Press STAY
Arms all devices and automatically bypass all motion detectors.
 Instant
From Home Screen: Press SECURITY, Uncheck ENTRY DELAY, Press STAY
Arms entry doors without delay and bypass all motion detectors.
 Maximum: From Home Screen: Press SECURITY, Uncheck ENTRY DELAY, Press
AWAY
Arms all devices and will arm all entry doors without an entry delay.
Turn System Off:
From Security Screen, Press DISARM, Enter Code.
Silence an Alarm:
From the Security Screen, Press Disarm, Enter Code.
Reset System/Clear Alarm History:
Check "Clear Alarm History" Button, Press OK
Door Chime On/Off:
2 Different Methods: All Chimes Off: Uncheck CHIME box on 2GIG Main
Menu Screen (From Home Screen Press SECURITY). Individual Chimes Off: Press TOOLBOX
button in Main Menu Screen. Enter Master User Code. From Toolbox menu, press CHIME SETUP.
Select sensor and Chime style/type.
Bypass A Zone:
2 METHODS AVAILABLE: Forced Bypass: From Arming Screen, Press
STAY or AWAY command. Press BYPASS ALL when prompted. Enter User Code.
Manually Bypass: Navigate to TOOLBOX from Main Security Menu Screen. Enter USER code,
Press Bypassed Sensors. Confirm Selections.
Panic Buttons:
Press
POLICE or EMERGENCY (EMS). Press and HOLD selection for 2 or more seconds.
Change or Add Additional Codes:
USER CODE MANAGEMENT. Enter Master Code (#1 User code). Select desired code to change
or next open user code line. Follow prompts to add code. Enable scheduling of code if desired.
Delete A User Code:
Navigate to TOOLBOX from Main Security Menu. Press USER CODE
MANAGEMENT. Enter Master Code (#1 User code). Select desired code to erase. Follow prompts
to erase code.
Sending a Test Signal:
Navigate to TOOLBOX from Main Security Menu. Press User Code.
Press arrow key to navigate to CELL PHONE TEST or TELEPHONE LINE TEST. Press Code.
Activate test.
856-854-9222 7215 Maple Ave. Pennsauken, NJ 08109 www.iAlarmNJ.com
From Home Screen, Press Red Bell Button
Emergency Button on Front of Alarm Keypad. Select FIRE,
Navigate to TOOLBOX from Main Security Menu. Press
,