2gig Technologies Go Control Quick Manual

Browse online or download pdf Quick Manual for Security System 2gig Technologies Go Control. 2gig Technologies Go Control 1 pages. Panel keypad

Print Page

2GIG Go Control Keypad

2GIG Home Screen

2GIG Main SECURITY Menu

2GIG Arming Screen

2GIG PANEL

KEYPAD QUICKGUIDE

– All protected windows and doors must be closed. Ready light should

Arm System

be green.

 Away— From Home Screen- Press SECURITY button, Press ARM button, Press AWAY

Arms all devices including motion detectors.

 Stay— From Home Screen- Press SECURITY button, Press ARM button, Press STAY

Arms all devices and automatically bypass all motion detectors.

 Instant

—

From Home Screen: Press SECURITY, Uncheck ENTRY DELAY, Press STAY

Arms entry doors without delay and bypass all motion detectors.

 Maximum: From Home Screen: Press SECURITY, Uncheck ENTRY DELAY, Press

AWAY

Arms all devices and will arm all entry doors without an entry delay.

Turn System Off:

From Security Screen, Press DISARM, Enter Code.

Silence an Alarm:

From the Security Screen, Press Disarm, Enter Code.

Reset System/Clear Alarm History:

Check "Clear Alarm History" Button, Press OK

Door Chime On/Off:

2 Different Methods: All Chimes Off: Uncheck CHIME box on 2GIG Main

Menu Screen (From Home Screen Press SECURITY). Individual Chimes Off: Press TOOLBOX

button in Main Menu Screen. Enter Master User Code. From Toolbox menu, press CHIME SETUP.

Select sensor and Chime style/type.

Bypass A Zone:

2 METHODS AVAILABLE: Forced Bypass: From Arming Screen, Press

STAY or AWAY command. Press BYPASS ALL when prompted. Enter User Code.

Manually Bypass: Navigate to TOOLBOX from Main Security Menu Screen. Enter USER code,

Press Bypassed Sensors. Confirm Selections.

Panic Buttons:

Press

POLICE or EMERGENCY (EMS). Press and HOLD selection for 2 or more seconds.

Change or Add Additional Codes:

USER CODE MANAGEMENT. Enter Master Code (#1 User code). Select desired code to change

or next open user code line. Follow prompts to add code. Enable scheduling of code if desired.

Delete A User Code:

Navigate to TOOLBOX from Main Security Menu. Press USER CODE

MANAGEMENT. Enter Master Code (#1 User code). Select desired code to erase. Follow prompts

to erase code.

Sending a Test Signal:

Navigate to TOOLBOX from Main Security Menu. Press User Code.

Press arrow key to navigate to CELL PHONE TEST or TELEPHONE LINE TEST. Press Code.

Activate test.

856-854-9222 7215 Maple Ave. Pennsauken, NJ 08109 www.iAlarmNJ.com

From Home Screen, Press Red Bell Button

Emergency Button on Front of Alarm Keypad. Select FIRE,

Navigate to TOOLBOX from Main Security Menu. Press