- ページ 10

電動工具 Gage Bilt GB730のPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Gage Bilt GB730 14 ページ。 Installation tool
Gage Bilt GB730 にも：ユーザーマニュアル (13 ページ)

HEAD

WARNING:

Dispose of hydraulic oil in accordance with all environmental regulations applicable in your area.

Remove nose assembly from tool before attempting disassembly of head cylinder assy.

Remove end cap (730717). Push against threaded end of piston (730311) to slide it out of head cylinder (730398). Be careful not to

damage threads or cause burrs on polished piston (730311) surface.

The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242 and torque

the four button-head cap screws (A-928) uniformly to 40 inch lbs. to prevent leakage around the gasket (745124).

WARNING:

This tool incorporates a patented hydraulic relief valve. When overhauling tool, o'ring (S829), back-up ring

(401084), retaining ring (400935) and spring (50806) must be replaced. Failure to do so could result in SEVERE

PERSONAL INJURY!

S/N: 2317 AND ABOVE

PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

O'RING - S829

BACK - UP RING - 401084

SPRING - 50806

RETAINING RING - 400935

PISTON ROD ASSY. - 730233

Rev. 2/15