Gage Bilt GB730 Kurulum Kılavuzu - Sayfa 10

Elektrikli Alet Gage Bilt GB730 için çevrimiçi göz atın veya pdf Kurulum Kılavuzu indirin. Gage Bilt GB730 14 sayfaları. Installation tool
Ayrıca Gage Bilt GB730 için: Kullanıcı Kılavuzu (13 sayfalar)

Sayfayı Yazdır
Gage Bilt GB730 Kurulum Kılavuzu
HEAD
WARNING:
Dispose of hydraulic oil in accordance with all environmental regulations applicable in your area.
Remove nose assembly from tool before attempting disassembly of head cylinder assy.
Remove end cap (730717). Push against threaded end of piston (730311) to slide it out of head cylinder (730398). Be careful not to
damage threads or cause burrs on polished piston (730311) surface.
The re-assembly sequence is the opposite of disassembly. (See Filling and Bleeding instructions.) Apply Loctite® #242 and torque
the four button-head cap screws (A-928) uniformly to 40 inch lbs. to prevent leakage around the gasket (745124).
WARNING:
This tool incorporates a patented hydraulic relief valve. When overhauling tool, o'ring (S829), back-up ring
(401084), retaining ring (400935) and spring (50806) must be replaced. Failure to do so could result in SEVERE
PERSONAL INJURY!
S/N: 2317 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
O'RING - S829
BACK - UP RING - 401084
SPRING - 50806
RETAINING RING - 400935
10
PISTON ROD ASSY. - 730233
Rev. 2/15