- ページ 10

シュレッダー Great Circle LCE01のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Great Circle LCE01 18 ページ。 Chipper shredder

3. Always use the hopper handle and built-in wheels to move the chipper shredder. Never lift the unit using the fuel

tank for support. If the unit must be lifted , always use at least two people, and always grip the unit securely

using the front leg and hopper handle.

4. Always follow the engine manual instructions for storage preparations before storing the unit for both short and long

term periods.

5. Always follow the engine manual instructions for proper start-up procedures when returning the unit to service.

6. Never store the unit or fuel container inside where there is an open flame or pilot light, such as in a water heater.

Allow unit to cool before storing.

Storage

Perform engine maintenance and storage measures listed in the engine owner's manual. This includes draining the

fuel system, or adding stabilizer to the fuel.

GASOLINE FIRES AND HANDLING FUEL SAFETY)

Before starting the unit after it has been stored:

1. Check all fluid levels. Check all maintenance items.

2. Perform all recommended checks and procedures found in the engine owner's manual.

3. Allow the engine to warm up for several minutes before use.

MAINTENANCE

Schedule & Procedures

The following schedule should be followed for normal care of your unit.

SAFETY ITEMS

Check for loose hardware

Check all safety labels

Inspect cone, hopper, and guards

CHIPPER MAINTENANCE ITEMS

Clean debris from engine and chipper

Inspect/Rotate Shredding Hammers

Inspect/Rotate Chipping Knives

Engine Maintenance

Refer to the engine manual included in your package for information on engine maintenance. Your engine manual

provides information and a maintenance schedule for performing the following tasks:

1. Always check oil level before starting engine. Refer to engine manual for capacity and type of oil to use.

2. Change oil after first 5-8 hours of operation. Change oil while engine is warm. Refill with new oil of recommend-

ed grade.

4. Check spark plug yearly or every 50 hours of operation.

5. Service air cleaner.

6. Keep engine and parts clean.

7. Check engine and equipment often for loose nuts and bolts, keep these items tightened.

Check for Loose Hardware

1. Service Interval: Every 5 hours; every spring and fall.

2. Inspect the unit, checking for loose hardware or components.

3. Pay special attention to the hardware attaching the chipper cone, hopper, axle, and front leg.

NOTE: Do not store a fueled unit in an enclosed structure. (SEE

BEFORE

EVERY

EACH USE

5 HOURS

25 HOURS

EVERY

100 HOURS

250 HOURS

SPRING

& FALL