- ページ 4

アダプター Active Silicon AS-ADP-SDI-001-AのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Active Silicon AS-ADP-SDI-001-A 6 ページ。 Harrier sdi adapter

QUICK START GUIDE

HARRIER SDI Adapter

Version 1.3 July 2019

Running the Harrier Example Application

Once installed, the Harrier USB SDK and example application appear in the Windows Start Menu,

under "Harrier USB Adapter SDK" (see Figure 6).

Figure 6: Harrier USB SDK installation in Windows 10 Start menu

After installing the SDK and drivers, plug the USB type C cable into the USB VIDEO OUT port and

open the Harrier Example Application from the Windows 10 Start menu. The application will

automatically select a USB video device and display the video from this device in the application

window. If you are using a laptop with a built-in camera, the application will select either the laptop

camera or the Harrier SDI Adapter as the initial video device. To see video from the Harrier SDI

Adapter you may need to change the selected video device/channel:

Select: File->Choose Device and select the Harrier SDI Adapter video channel as shown below.

Figure 7: Selecting the USB C video output from the Harrier SDI Adapter

The application will then display a set of supported video modes. The Harrier SDI Adapter will be

using the same mode as the camera that it is connected to.

Note: 1920 x 1080 @ 60 FPS is normally the default mode for Active Silicon Camera Interface Board

evaluation kits, so please select that mode (unless you have set the camera into a different mode,

e.g. you may have set a 1280 x 720 mode to support parallel analog video output).

Page 4 of 6