Active Silicon AS-ADP-SDI-001-A Skrócona instrukcja obsługi - Strona 4
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Adapter Active Silicon AS-ADP-SDI-001-A. Active Silicon AS-ADP-SDI-001-A 6 stron. Harrier sdi adapter
Drukuj stronęQUICK START GUIDE
HARRIER SDI Adapter
Version 1.3 July 2019
Running the Harrier Example Application
Once installed, the Harrier USB SDK and example application appear in the Windows Start Menu,
under "Harrier USB Adapter SDK" (see Figure 6).
Figure 6: Harrier USB SDK installation in Windows 10 Start menu
After installing the SDK and drivers, plug the USB type C cable into the USB VIDEO OUT port and
open the Harrier Example Application from the Windows 10 Start menu. The application will
automatically select a USB video device and display the video from this device in the application
window. If you are using a laptop with a built-in camera, the application will select either the laptop
camera or the Harrier SDI Adapter as the initial video device. To see video from the Harrier SDI
Adapter you may need to change the selected video device/channel:
Select: File->Choose Device and select the Harrier SDI Adapter video channel as shown below.
Figure 7: Selecting the USB C video output from the Harrier SDI Adapter
The application will then display a set of supported video modes. The Harrier SDI Adapter will be
using the same mode as the camera that it is connected to.
Note: 1920 x 1080 @ 60 FPS is normally the default mode for Active Silicon Camera Interface Board
evaluation kits, so please select that mode (unless you have set the camera into a different mode,
e.g. you may have set a 1280 x 720 mode to support parallel analog video output).
Page 4 of 6