- ページ 8

エアコン Aircommand HERON 2.2のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Aircommand HERON 2.2 17 ページ。
Aircommand HERON 2.2 にも：取付説明書 (10 ページ)

■

Insert the A/H into the front panel, and shift to the right as far as possible such that the right hand

flange is fully over the front panel. Now insert a screw to hold the A/H in place while the copper tubes

are manipulated to line up with the respective nipples.

Mark any excess tube to be cut off, and remove the A/H to allow the flare nuts to be put on and the

flares made. Unscrew both flare nuts from the nipples of the A/H, ensuring the sealing caps are

removed.

See page 6 for tips on making flares.

Having completed the flaring, reinstall the A/H, remembering to shift it fully to the right after insertion.

Couple the flare nut connections and do up firmly.

INSTALL BITUMINOUS TAPE AROUND 9.5 FLARE NUT AT THE A/H.

From the Installation kit provided, take the length of bituminous tape and wrap it around the

and joining the foam rubber insulation already on the pipe. The purpose of this is to avoid formation of

condensate, which may drip into the cupboard. Install control plate.

Never ever use thread sealing compounds on the flare as possible system contamination can occur and a

blockage may result.

1. Plug service lead into power point but leave the

power turned off (see fig 14)

2. Plug the condenser set control cable (3 pin plug)

and the Air Handler control cable (8 pin plug) into

their respective sockets at the back of the switch

box (see fig 15).

3. Turn power point on.

4. Push control panel flush against the face of the

cupboard and then slide to the right to engage

with the fascia panel. Hold the control panel in

place with two screws. Cover screw heads with the

caps provided. (see fig 16)

flare nut

Figure 14

Figure 15

Figure 16