- ページ 10

産業機器 6K Products 25G36のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。6K Products 25G36 17 ページ。 Connect and cut hydraulic chain

Operating Instructions

Before, and periodically during, operation you must check the bar oil level and chain tension. We recommend using

a good quality bar oil of the correct viscosity for your areas operating temperatures. Because of the wide

temperature range between winter and summer two different viscosity oils may be required. Tension the chain as

described on page 6. The log being cut must be clamped prior to sawing. Once the log is positioned and clamped the

saw control valve needs to be opened for full flow to cut. After completing the cut reverse the valve and raise the

saw bar. The saw motor only runs when the bar is being lowered. The bar will only receive up to 32 cc of oil when

the saw motor is operating or the bar is feeding down.

For parts and service contact 6K Products. Our hours of operation are 8:00 AM to 4:30 PM, Monday through Friday,

Pacific Time excluding holidays.

Phone: 360-264-2141

Fax: 360-264-5105

Mail and shipping address:

6K Products

1006 143

Ave. S.E.

Tenino, WA 98589