- ページ 2

農機具 GREAT PLAINS 1205NTのPDF フィールド調整マニュアルをオンラインで閲覧またはダウンロードできます。GREAT PLAINS 1205NT 5 ページ。 End wheel no-till drill
GREAT PLAINS 1205NT にも：プレデリバリーマニュアル (20 ページ)

ページを印刷する

Transporting The Drill:

When transporting the drill, the transport locks should

always be used. This will prevent damage to the drill and

possible personal injury should hydraulic failure occur.

1) To install the transport locks, fully raise the drill and

place the transport lock onto the rod of the cylinder and

secure it in place with a pin and clip.

2) Always disengage the lockout hub before transporting

the drill.

Hitching The Drill To The Tractor:

1) With the drill lowered and tongue jack in the parking

position, level the tongue, then back the tractor to the drill

hitch and adjust to match the draw bar height. Adjust the

hitch height as needed with the implement jack to match

the draw bar.

2) After hooking the drill to the tractor and attaching the

hydraulic hoses, raise the drill up to the maximum height

and hold the hydraulic lever for 30 seconds to re-phase

the cylinders. This procedure will remove any air in the

system, allowing the drill to raise and lower evenly. The

re-phasing procedure should be repeated several times

a day to ensure that the drill continues to lift evenly.

Remove the transport locks.

Document

#DRUS500C-0002A

48728

48710

48713

2 of 5