GREAT PLAINS 1205NT Посібник з польових налаштувань - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з польових налаштувань для Сільськогосподарське обладнання GREAT PLAINS 1205NT. GREAT PLAINS 1205NT 5 сторінок. End wheel no-till drill
Також для GREAT PLAINS 1205NT: Посібник з передпологової підготовки (20 сторінок)
Друкувати сторінкуTransporting The Drill:
When transporting the drill, the transport locks should
always be used. This will prevent damage to the drill and
possible personal injury should hydraulic failure occur.
1) To install the transport locks, fully raise the drill and
place the transport lock onto the rod of the cylinder and
secure it in place with a pin and clip.
2) Always disengage the lockout hub before transporting
the drill.
Hitching The Drill To The Tractor:
1) With the drill lowered and tongue jack in the parking
position, level the tongue, then back the tractor to the drill
hitch and adjust to match the draw bar height. Adjust the
hitch height as needed with the implement jack to match
the draw bar.
2) After hooking the drill to the tractor and attaching the
hydraulic hoses, raise the drill up to the maximum height
and hold the hydraulic lever for 30 seconds to re-phase
the cylinders. This procedure will remove any air in the
system, allowing the drill to raise and lower evenly. The
re-phasing procedure should be repeated several times
a day to ensure that the drill continues to lift evenly.
Remove the transport locks.
Document
#DRUS500C-0002A
48728
48710
48713
2 of 5