GREAT PLAINS 1205NT Посібник з польових налаштувань - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник з польових налаштувань для Сільськогосподарське обладнання GREAT PLAINS 1205NT. GREAT PLAINS 1205NT 5 сторінок. End wheel no-till drill
Також для GREAT PLAINS 1205NT: Посібник з передпологової підготовки (20 сторінок)
Друкувати сторінкуLeveling The Drill:
1) Loosen the locknuts (1) and adjust the cylinder eye-
bolts (2) so that there is initially about 3 1/16 inch of
thread above the mounting plate.
2) Fully raise the drill, then lower the drill to the ground
until the openers and coulters are 1 to 2 inches off the
ground.
3) Measure the distance from the coulter tube to the
ground on both ends of the drill.
4) Adjust the eye-bolts to level the drill from end to end.
5) Tighten the nuts on eye-bolts when the drill is level.
Coulter Depth Control:
The master-slave lift cylinder on the drill controls the
depth of the coulters. A depth valve regulates the
retracted length of these cylinders.
1) Lower the drill until the desired coulter depth is
achieved and set the coulter depth stop. Raise the drill
up and drive forward while lowering the drill as it's mov-
ing. Recheck the coulter depth and adjust, by doing this
the coulter depth will always return to the same depth.
Note: Changing the depth of the coulters will effect over-
all planting depth of the openers. Press wheels will need
to be adjusted accordingly.
Individual Coulter Adjustment:
Coulter springs are preset at the factory giving the
coulters an initial operation force of 400+ lbs. This setting
is adequate for most fields conditions. Re-setting the
coulter spring shorter than 9 3/4 inches can cause pre-
mature failure of parts.
Opener Down Pressure:
The "W" clips on the opener spring rods should be in the
lowest hole. This is the correct location in all conditions.
The "W" clips can be raised one hole on openers in wheel
tracks only if penetration is not adequate.
2
1
48725
48711
48646
48645
3 of 5
3 1/16"
Document
#DRUS500C-0002A