- ページ 8

ホブ Gaggenau VG 231 120 INのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Gaggenau VG 231 120 IN 16 ページ。 Gas wok

ページを印刷する

Operating the appliance

Setting up the burner

The torch parts should be fitted and hung up, otherwise

it may cause malfunction in the ignition state or during

operation. Fit the burner head so that the thermocouple

in the corresponding recess is positioned at the tip of

the burner. The snap-on lock must be snapped in place

at the corresponding recess on the burner head on the

burner ring.

Operating the appliance

N otes

O p e r a t i n g t h e a p p l i a n c e

–

Only use the accessories specified. Do not line the

stainless steel recess (e.g. with aluminium foil).

–

Do not cover the ventilation openings on the back

of the control panel.

–

The burner and ignition plug must be clean and dry.

–

Only light the burners if the pan supports and all

burner parts are correctly fitted.

–

To ignite a burner, firmly press the control knob

down as far as possible and hold it there, then turn

it to the required position.

–

Once ignited, press and hold the control knob for

approx. 2 to 4 seconds to enable the heat sensor

that opens the gas flow to heat up first.

–

If the flame does not ignite within 2 to 4 seconds,

turn the control knob anti-clockwise to the lowest

setting and, once ignited, turn it back to the highest

setting. It can often be quicker to ignite the burner

in the lowest setting because different gases have

different ignition characteristics.

–

When one burner is ignited, an ignition spark will

also be generated at all the other burners.

–

Do not touch the ignition plug while the gas

appliance is being lit.

–

It is important to keep the appliance clean. If the

ignition plugs are dirty, this may cause ignition

problems. Clean the ignition plugs regularly with a

small, non-metallic brush. Take care to prevent the

ignition plugs from suffering any heavy knocks.