- ページ 4

農機具 GREAT PLAINS 606NTのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。GREAT PLAINS 606NT 6 ページ。 Six foot no-till drills
GREAT PLAINS 606NT にも：メンテナンス・マニュアル (7 ページ)

Determine the new bar length required.

4) Loosen the clamp bolts (2) and use a mallet to adjust the

bar height. Once the desired height is achieved, re-tighten the

clamp bolts.

Coulter Down-Force Adjustment:

Coulter springs are preset at the factory giving the coulters an

initial operation force of 400+ lbs. This setting is adequate for

most field conditions. Re-setting the coulter spring shorten

than 9 3/4 inches can cause premature failure of parts.

Opener Down Pressure:

The "W" clips located on the opener spring rods should be in

the lowest hole. This is the correct location in all conditions.

The "W" clips can be raised one hole on openers behind wheel

tracks only if penetration is not adequate.

T-Handle Adjustment:

The depth of each opener is controlled by the height of the

press wheel. Varying the height of the press wheel changes

the seeding depth of the opener. Moving the "T" handle to the

front of the opener shallows the depth; moving the "T" handle

towards the rear of the opener increases the depth. For a start-

ing point, place the "T" handle in the center.

Document

#DRUS500C-0003A

48742

48646

48645

48642

4 of 6