- ページ 7

サンダー Hi-Tech Diamond All-U-NeedのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Hi-Tech Diamond All-U-Need 16 ページ。

Operating Instructions

Carefully unpack the All-U-Need from the box and check all packaging material to make certain no

accessories or small parts are inadvertently discarded. Should the machine arrive damaged,

IMMEDIATELY contact the shipping company. If there are any missing parts or defects in the material

or workmanship, contact Hi-Tech Diamond for repair or replacement at [email protected].

Make sure the machine sits level on the table you are working on and the white catch tray is

securely mounted on a horizontal plane on the motor housing. If the tray is raised or tilted, it will hit the

motor shaft or silver arbor and rub, causing a squeaking sound on the 2" arbor.

Install the water system by inserting the black tube with valve into the white cup with the hole.

Position the cup on top of the spray shield. Insert the clear drain tube into the drain hole on the bottom

right side of the white catch tray. Position the other white cup under the drain tube. See cover image for

correct water set-up. Fill the top cup with CLEAN water. NEVER re-use water.

Among the accessories included with your All-U-Need, you will find four colored Diamond

Smoothing Discs, one white Tech-10 Pad, and four backing plates. To prepare these items for use,

they must first be assembled. To do this, remove the protective backing from the Diamond Smoothing

Discs. Make sure to center properly. The disc may be slightly smaller than the backing plate. Improper

centering may cause the disc to spin out of round resulting in machine vibration. Apply the exposed

pressure sensitive adhesive to the clean, smooth surface of a hard backing plate. Make sure the discs

have an even contact with the backing plate surface. Clip a hole with a sharp knife, following the 1/2"

center hole in the backing plate (FIG. A). This is where the 1/4"-20 thread black knob goes through.

Set the 180 Mesh Electroplated Diamond Disc on the arbor and secure with the 1/4"-20 thread

knurled black knob and washer (FIG. B). This is the first disc you need to use to start shaping your

rough material. Put on your safety goggles (not included) and turn the power switch on. Adjust the

water drip so that the water is aimed at the center of the disc. You only need drops of water to

adequately cover the discs. You can control the splash by raising or lowering the black splash guard.

Screws can be adjusted to

raise and lower splash guard

Screws can be adjusted to

raise and lower splash guard