ページを印刷する
- 1. Table of Contents
- 2. Full Set [1]
- 3. Part Set [2]
- 4. Night Set [3]
- 5. Unsetting
- 6. Unsetting after or During an Alarm
- 7. Testing the System [5]
- 8. Reprogramming Codes [8]
- 9. Isolating Zones [6]
- 10. Chime Facility [9]
- 11. Viewing the Alarm Log [0]
- 12. Indicators and What They Mean
- 13. System Settings
- 14. System Limitations
FULL SET [1]
FULL SET [1]
All system detectors must be clear before
setting.
To start the Full setting of the system enter
your User Code then press the 1 (Full Set)
key. A constant exit tone will be heard which
changes to an interupted tone as you pass
and activate the detectors on the exit route.
The Day LED on the keypad flashes during
the exit period. The last detector on the exit
route does not cause an interupted tone. To
√ √
cancel the system setting press the
(Escape) key.
When the system has set, you will hear two
confirmation beeps. After this the √ √ key will
not function.
Easy Set – if programmed, allows you may
start the system setting by pressing the # key
then the 1 (Full Set) key.
PART SET [2]
PART SET [2]
To Part Set the alarm system enter your User
Code then press the 2 (Part Set) key. This
sets a sub-part of the system and leaves the
rest unset – the installation engineer will
advise you on how your system has been
programmed for Part Set, also see System
Settings on Page 7. To cancel the setting
press the √ √ (Escape) key.
The setting routine is as described in Full Set
[1].
Easy Set – if programmed, allows you may
start the system Part setting by pressing the #
key then the 2 (Part Set) key.
2