ADEMCO Accord Instrukcje użytkownika - Strona 2

Przeglądaj online lub pobierz pdf Instrukcje użytkownika dla System bezpieczeństwa ADEMCO Accord. ADEMCO Accord 10 stron.

FULL SET [1]

All system detectors must be clear before

setting.

To start the Full setting of the system enter

your User Code then press the 1 (Full Set)

key. A constant exit tone will be heard which

changes to an interupted tone as you pass

and activate the detectors on the exit route.

The Day LED on the keypad flashes during

the exit period. The last detector on the exit

route does not cause an interupted tone. To

√ √

cancel the system setting press the

(Escape) key.

When the system has set, you will hear two

confirmation beeps. After this the √ √ key will

not function.

Easy Set – if programmed, allows you may

start the system setting by pressing the # key

then the 1 (Full Set) key.

To Part Set the alarm system enter your User

Code then press the 2 (Part Set) key. This

sets a sub-part of the system and leaves the

rest unset – the installation engineer will

advise you on how your system has been

programmed for Part Set, also see System

Settings on Page 7. To cancel the setting

press the √ √ (Escape) key.

The setting routine is as described in Full Set

[1].

Easy Set – if programmed, allows you may

start the system Part setting by pressing the #

key then the 2 (Part Set) key.