- ページ 7

コントローラー Active-semi HYDRA-X BLDCのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Active-semi HYDRA-X BLDC 13 ページ。 Power application controllers

Power Input

Power to the Hydra-X BLDC Head module should be applied to the J7/J8 Spade connectors. Power to the

module should not exceed 48V.

Powering the HYDRA-X BLDC Head through the J7/J8 connectors will power the HYDRA-X20 Body board.

Power to the body board is applied through the J4 VIN and GND terminal.

NOTE: Applying power to the HYDRA-X BLDC system through the HYDRA-X20 J7 connector is not

recommended. Since this is a high current application, and the header connectors are not rated to handle

such high currents, it is crucial that current is supplied through the spade connectors into the headers and not

vice versa.

The HYDRA-X BLDC Head is not protected against voltage reversal. Voltage polarity must be observed

before applying power to the module. Failing to follow correct voltage polarity connections will adversely affect

HYDRA-X BLDC Head power FETs.

Rev 1.0 June 2014