- ページ 6

扇風機 DYNABREEZE FA-23105のPDF ユーザーマニュアルと保証をオンラインで閲覧またはダウンロードできます。DYNABREEZE FA-23105 12 ページ。 Industrial 750mm pedestal fan
DYNABREEZE FA-23105 にも：取扱説明書 (12 ページ)

ページを印刷する

USING YOUR DYNABREEZE FAN

UNPACKING AND BUILDING THE FAN

1. Unpack the unit from box that your

unit was purchased in and recycle the

packaging if possible.

2. Check that all the parts are included on

the unit and nothing is broken. If you

require assistance, please contact the

place of purchase.

3. Attach the pedestal stand column to the

pedestal stand base and secure with the

provided bolt and spring washer by using

a spanner or socket.

4. Unscrew and take out the height

adjustment locking bolt from the pedestal

stand column.

5. Slide the height adjustment bolt cover

down the column to rest on the pedestal

stand base.

6. Pull out the pedestal column extension

tube inside the pedestal column and reﬁ t

the height adjustment locking bolt and

cover.

CAUTION: The locking bolt must be fully

tightened before continuing to assembling

the motor section to the pedestal stand.

7. Fit the electric motor to the pedestal

stand and tighten the bolt.

CAUTION: The bolt must be fully tightened

before the fan is operated.

6 DYNABREEZE INDUSTRIAL STRENGTH FAN

8. Set the rear safety grille in position and ﬁ x

it in position using the 4 provided bolts,

until tight.

9. Install the blade onto the electric motor

shaft and screw the blade retaining bolt

until tight.

10.Open clips on the front safety grille and

place front safety grille onto rear safety

grille (align locking screw holes) and close

clips.

11. Secure both guards ﬁ rmly by ﬁ tting and

tightening the locking screw and nut.

FIRST USE AND OPERATION OF THIS FAN

1. Read and follow this manual and adhere

to all safety precautions.

2. Plug the power cable into a suitable

power outlet and switch on the power

outlet.

3. Set the fan on a ﬁ rm, level dry surface.

4. The Oscillating Control: The oscillating

structure is shown in the diagram, it can

be adjusted in the angle from 0°-90°.

When adjusting screw is moved to the

direct axle, the fan will not oscillate. The

longer – the distance from the adjusting

to the direct axle is, the larger the

oscillating angle will be.

NOTE: Always switch o and unplug the unit

from the power outlet before changing the

oscillating angle. Loosen the adjusting screw

on the oscillating control turn the fan to the

desired angle.