- ページ 6

おもちゃ Aircraft In Miniature HW72-03-001のPDF 歴史、注意事項、組み立て説明書をオンラインで閲覧またはダウンロードできます。Aircraft In Miniature HW72-03-001 9 ページ。 1:72 metal kit of the 1909 santos dumont demoiselle

ページを印刷する

(3) Put the axle through the holes in the lugs on the airframe (enlarge these

holes if necessary) and put the other wheel on to the axle.

(4) Trim the axle to length, so that there is approximate 1 mm projecting from

the hub of the other wheel.

(5) Attach the inner and outer landing gear struts. Put the lower end of each

strut on the axle and attach the upper end to the front spar against the

lugs on the spar.

C Assemble the tail landing gear

(1) Fold the tail landing gear stirrup (stirrup) as shown.

(2) Make the axle from the wire supplied.

(3) Put the axle through the holes in the stirrup and wheel and bond the axle

in position.

(4) Attach the top of the stirrup to the underside of the fuselage structure.

(5) Attach the skid to the top longeron of the fuselage structure.

REAR FUEL TANK

SUPPORT

FRONT FUEL TANK

SUPPORT

FUEL TANK

SUMP

(nickel silver part)

FUEL PIPE

(nickel silver part)

5 FINAL ASSEMBLY

A Fuel tank assembly:

(1) Cut two slots in the cast metal fuel tank for the two supports.

(2) Attach the supports to the fuel tank.

(3) Attach the fuel tank sump (an etched nickel silver part) to the underside of the

fuel tank.

(4) Attach the supports to the top of the wing. If you intend to cover the wing with

Litespan film, attach this assembly after the wing is covered.

B Curve the seat as shown, then attach it to the fuselage structure.

C Attach the control wheel to the left angled strut.

(see Figure 5, Detail C).

SLOTS IN FUEL TANK

FOR SUPPORTS

Figure 6

(see Figure 6)

FUEL TANK

CONTROL

COLUMN

SEAT

CONTROL

WHEEL