Aircraft In Miniature HW72-03-001 Історія, примітки та інструкції по збірці - Сторінка 6
Переглянути онлайн або завантажити pdf Історія, примітки та інструкції по збірці для Іграшка Aircraft In Miniature HW72-03-001. Aircraft In Miniature HW72-03-001 9 сторінок. 1:72 metal kit of the 1909 santos dumont demoiselle
Друкувати сторінку(3) Put the axle through the holes in the lugs on the airframe (enlarge these
holes if necessary) and put the other wheel on to the axle.
(4) Trim the axle to length, so that there is approximate 1 mm projecting from
the hub of the other wheel.
(5) Attach the inner and outer landing gear struts. Put the lower end of each
strut on the axle and attach the upper end to the front spar against the
lugs on the spar.
C Assemble the tail landing gear
(1) Fold the tail landing gear stirrup (stirrup) as shown.
(2) Make the axle from the wire supplied.
(3) Put the axle through the holes in the stirrup and wheel and bond the axle
in position.
(4) Attach the top of the stirrup to the underside of the fuselage structure.
(5) Attach the skid to the top longeron of the fuselage structure.
REAR FUEL TANK
SUPPORT
FRONT FUEL TANK
SUPPORT
FUEL TANK
SUMP
(nickel silver part)
FUEL PIPE
(nickel silver part)
5 FINAL ASSEMBLY
A Fuel tank assembly:
(1) Cut two slots in the cast metal fuel tank for the two supports.
(2) Attach the supports to the fuel tank.
(3) Attach the fuel tank sump (an etched nickel silver part) to the underside of the
fuel tank.
(4) Attach the supports to the top of the wing. If you intend to cover the wing with
Litespan film, attach this assembly after the wing is covered.
B Curve the seat as shown, then attach it to the fuselage structure.
C Attach the control wheel to the left angled strut.
(see Figure 5, Detail C).
SLOTS IN FUEL TANK
FOR SUPPORTS
Figure 6
(see Figure 6)
FUEL TANK
CONTROL
COLUMN
SEAT
CONTROL
WHEEL