- ページ 2

ドローン＆クアッドコプターアクセサリー 7SenseTech Hawk 4KのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。7SenseTech Hawk 4K 10 ページ。

ページを印刷する
Precautions
Safe Flying Tips
1. Fly in an opebn area as the drone relies heavily on a strong GPS signal (that can be easily
weakened or distorted by nearby structures). Please avaoif flying it indoor.
2. Place the aircraft on a flat ground before take-off. After power on, the drone will run the
calibration of fly control system and the gimbal. Do not touch or move the drone during
self-checking (as it may result in an errorneous level calibration and failure in checking)
3. Do not take off until the drone gets enough satellites and an "
watch. Do not start the follow me flight mode until the watch gets 8 GPS satellites and
shows an icon of "
"
4. It is highly recommended to stand at least 5 meters away from the drone when it takes off
to avoid any injury that may arise from the moving rotors.
5. If the drone suddenly deviates or keeps ascending over 6 meters due to surrounding
interference, immidiately press the "land" button to force the drone to land safely.
6. Ensure all components are properly assembled and the drone is fully charged before
every flight.
*Notes: Keep the drone far away from by-standers,
trees, electric wires and buildings.
*Notes: Do not fly in strong winds, rain, lightning,
snow or fog.
*Notes: Do not fly over roads or near metal
structure with a strong magnetic field.
"icon shows on the
Notes: Please keep the flight altitude and
range within 30 meters.
30 meters
Keep flight height less than 30 meters.
*Notes: Keep the drone within your line of
sight. Do not fly across buildings or any other
obstacles which may make you lose sight
of the aircraft and cause possible
loss of radio connection.
Notes:
Do not fly over crowds. Keep people more
than
5 meters
away from the drone to
avoid injury by rotors.
10 m
5m 〈
Step1
Charging (Diagram 1)
Turn on the battery, watch and camera to check the battery level before
assembling.
Insert the AC power cord into the charger and plug into a 100-240V AC
socket. All LEDs will light for 1 second and then the charger is ready to
use.
Connect battery to the balance charger with a 4pin balance plug.
When the battery is charging, the LEDs will light up and indicate the battery
level.
The LEDs on the balance charger will also flash one by one and indicate
the charging progress.
When all 4 LEDs light up, it means the battery is fully charged.
Diagram1：
Battery Balance Plug
Battery
Charger
AC Power Cord
Battery Charging Time: 2 hours
Notes: Connect the balance plug with battery in accordance with the arrow indications. Otherwise, all 4 LEDs
of charger will flash continuously and the battery will not get charged.
Assembly
USB Charge Port
Camera
Watch
Watch and camera use the same
usb cable to charge.
Watch and Camera Charging Time: 30 minutes