- ページ 12

おもちゃ GREAT PLANES Dazzler ARFのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Dazzler ARF 20 ページ。

17. After the radio and battery have been installed it is

recommended that you place another small piece of foam on

top of the receiver and then hold the receiver in place with a

balsa stick (not included) as shown in the photograph.

18. Cut away the covering where the pushrods exit the

fuselage. Install the two 36" [900mm] solid wire pushrods into

the plastic outer pushrod tubes. Be sure the threaded end of

the pushrod exits at the rear of the fuselage.

19. Install a silicone clevis keeper onto the threaded end

of the rod. Install a clevis onto the threaded end of the rod

by turning the clevis onto the threads 14 turns.

Hinge Line

Correct

20. Locate one of the nylon control horns and the control

horn mounting plate. Position the control horn on the left side

of the rudder, in line with the solid wire pushrod, centering the

control horn on the hinge line as shown in the above diagram.

21. Mark the location of the screw holes for the control

horn. Drill a hole through the marks with a 1/16" [1.6mm] drill.

22. Install the control horn with two 2-56 screws. The

screws should pass through the horn and the rudder, then

screw into the control horn mounting plate on the opposite

side of the rudder.

Incorrect

23. Attach the clevis to the outermost hole in the horn,

then slide the silicone retainer over the clevis. Repeat this for

the elevator control horn.

24. Turn on your radio and receiver. Center the servos

and then install the servo arms as shown.

25. Center the elevator. Make a mark on the solid wire

pushrod where it lines up with the hole in the servo arm.

Make a 90-degree bend at the mark. Cut the rod above the

bend to a length of 3/16" [4.8mm].

Servo Horn

26. Install the rod into the hole in the servo arm and then

attach a Faslink to hold the pushrod to the servo arm.

27. Turn on the transmitter and receiver. Set the throttle to

full open. Install the braided cable into the screw-lock

connector, then open the carburetor on your engine to full

open. Insert the screw-lock connector into the outermost hole

in the servo arm following the same installation instructions

as you used attaching the cable to the throttle barrel during

the engine installation. Cut the excess cable with a sharp

wire cutter. Turn off the radio system when this is completed.

2-56 (.074") Pushrod Wire

FasLink