- ページ 14

おもちゃ GREAT PLANES Dazzler ARFのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Dazzler ARF 20 ページ。

INSTALLING THE LANDING GEAR

1. Draw a center line on the bottom of the fuselage in

front of the wing L.E., beginning where the fuselage meets

the radio compartment cover.

2. Measure from the back edge of the fuselage forward

1-3/4" [44mm]. Draw a line across the fuselage on this mark.

3. Locate the pre-bent wire landing gear. Place the wire

on the fuselage over the reference lines you have drawn,

aligning the center of the bend in the wire on the center line

of the fuselage.

4. Locate four humped nylon landing gear straps. Drill

1/16" holes in the fuselage for the straps, then screw them

in place as shown in the photograph using the #2 x 1/2"

[13mm] sheet metal screws.

5. Locate four 5/32" [4mm] wheel collars. Insert a

6-32 set screw into each one. Place one wheel collar onto

the main landing gear wire. Lock it in place onto the wire 1"

[25mm] from the end of the wire.

6. Insert a foam wheel onto the wire followed by

another wheel collar. Tighten the wheel collar in place on the

wire to lock the wheel in place. Hint: The wheel collar will

tighten better to the wire if you file a small flat spot where the

set screw contacts the wire.

7. Repeat this for the remaining wheel.

8. Locate the plywood mounting plate for the tailwheel

assembly. Place it on the bottom of the aft end of the

fuselage. Use a felt tip pen to mark the location of the plate

on the fuselage.

9. Cut away the covering inside of the lines you have

drawn. Then glue the plywood plate to the fuselage with

6-minute epoxy.

10. When the glue has cured, place the tailwheel

assembly in place on the plywood plate. Mark the locations

of the mounting holes. With a 3/64" [1.2mm] drill bit, drill

through the marks on the plywood plate.