- ページ 8

おもちゃ GREAT PLANES EP F-20 Tigershark ElectriFLyのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES EP F-20 Tigershark ElectriFLy 16 ページ。

INSTALL THE RADIO GEAR

With servos centered, position

each arm 90° to the servo case.

LEFT

Aileron Servo

❏

1. Use your radio to center each of your servos. Remove

the servo arms and reposition each one so that the servo arm

is 90° to the servo case. Prepare two aileron servos and one

elevator servo as shown in the sketch. Clip off the unused

servo arms. Reinstall the servo arm screw on each servo.

❏

2. Using a #57 [1.09mm] drill bit, enlarge the hole that is

5/16" [7.9mm] from the output shaft on each servo arm. If

you don't have a #57 drill bit, carefully use a hobby knife to

enlarge the hole until you can ﬁ t the 1mm Z-bend pushrods.

❏

3. Route the elevator servo lead through the slot in the

bottom of the fuselage. Make sure that the servo's output

shaft faces forward and the servo arm faces up toward the

top of the model. Clean the servo with denatured alcohol,

then glue into position as shown using thick or medium CA.

RIGHT

Aileron Servo

Elevator

Servo

❏

4. Identify the left and right aileron servos and tie each

servo lead guide string to its corresponding servo lead. Pull

each servo lead through the fuselage and glue each servo

in position.

❏

5. Remove the guide strings from the aileron servo wires.

Attach the supplied Y-harness to the two aileron servo leads

and the 14" [365mm] extension to the elevator servo lead using

electrical tape or 3/8" [9.5mm] diameter heat shrink tubing to

secure the connections. Tie the guide string to the aileron

Y-harness and the elevator extension lead and route the wires

into the radio compartment. Note: You should be careful to

match the polarity of the servo leads with the lead extensions.

❏

6. Pull the servo leads through the upper channel so that

they are positioned as shown. Route the elevator lead so that