- ページ 11

おもちゃ GREAT PLANES EP YAK 55 3D ARFのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES EP YAK 55 3D ARF 16 ページ。

2. Slide the gearbox onto the 10mm square stick in the

nose. Secure it with a screw.

3. Install the prop saver onto the gearbox output shaft.

The screws should seat down into the flat spots on the shaft.

4. Install the ESC as shown. If your ESC has a BEC

switch, install it in the provided cutout.

5. Attach the propeller to the prop saver with two

rubber bands.

Final Setup

1. Connect the servos and ESC to their channels on the

receiver. You may need to use extensions to allow the

aileron servo and ESC lead to reach the receiver. Power up

your radio system and center the servos. If necessary,

adjust the center point of the control surfaces by tightening

or enlarging the "V" bend in each pushrod.

2. Tape the receiver into its cavity on the fuselage, and cover

the servo wires in the groove with the red trim tape provided.

3. Apply the other piece of trim tape to the other side of

the fuselage to match.

4. Apply the red triangle trim to the bottom of the wing

1. Use scissors or a sharp hobby knife to cut the decals from

the sheet.

2. Be certain the model is clean and free from oily fingerprints

and dust. Prepare a dishpan or small bucket with a mixture of

liquid dish soap and warm water–about one teaspoon of soap