- ページ 7

おもちゃ GREAT PLANES Slow Poke Sport .40のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Slow Poke Sport .40 20 ページ。 Arf plane

6. Mix 4 oz. of 30-minute epoxy in a mixing cup. Apply

a liberal amount of epoxy into the wing joiner box in the wing

and the wing center section. Apply epoxy to the root rib of

the wing and the wing center section. Finally, apply epoxy to

both sides, the top and the bottom of the wing joiner. Insert

the joiner into the wing center section. Slide the right wing

panel onto the joiner. Wipe any excess epoxy from the wing

joint and clean any glue residue with rubbing alcohol. Hold

the wing and the wing center section together with masking

tape. Set the assembly aside until the glue has cured. Once

cured repeat steps 5 and 6 for the left wing panel.

7. On the top of the wing locate the two 1/4" [6mm] holes

in the wing center section at the trailing edge of the wing. Cut

away the covering material where these holes are located.

8. Locate the 2" x 4-1/2" [51 x 115mm] plywood wing

bolt plate. Draw a line on the center of the plate across the

2" width of the plate. On the bottom of the wing center

section, locate the center of the wing center section and

draw a line 3" long marking the center of the wing.

9. Place the plywood wing bolt plate on the bottom of the

wing center section at the trailing edge of the wing, aligning

the lines that you drew on the wing and the wing bolt plate.

Trace the plywood landing gear plate onto the center of the

wing with a marker. Cut away the covering inside of the lines

you have just traced onto the wing, being careful not to cut

into the wing sheeting.

10. Using 6-minute epoxy, glue the plywood wing bolt

plate to the wing center section in the area where you have

removed the covering.

11. Turn the wing over so that you are looking at the top

of the wing. Use a 17/64" [6.7mm] drill bit to drill through the

wing bolt holes into and through the landing gear plate.