GREAT PLANES Slow Poke Sport .40 Інструкція з експлуатації - Сторінка 7
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Іграшка GREAT PLANES Slow Poke Sport .40. GREAT PLANES Slow Poke Sport .40 20 сторінок. Arf plane
Друкувати сторінку
6. Mix 4 oz. of 30-minute epoxy in a mixing cup. Apply
a liberal amount of epoxy into the wing joiner box in the wing
and the wing center section. Apply epoxy to the root rib of
the wing and the wing center section. Finally, apply epoxy to
both sides, the top and the bottom of the wing joiner. Insert
the joiner into the wing center section. Slide the right wing
panel onto the joiner. Wipe any excess epoxy from the wing
joint and clean any glue residue with rubbing alcohol. Hold
the wing and the wing center section together with masking
tape. Set the assembly aside until the glue has cured. Once
cured repeat steps 5 and 6 for the left wing panel.
7. On the top of the wing locate the two 1/4" [6mm] holes
in the wing center section at the trailing edge of the wing. Cut
away the covering material where these holes are located.
8. Locate the 2" x 4-1/2" [51 x 115mm] plywood wing
bolt plate. Draw a line on the center of the plate across the
2" width of the plate. On the bottom of the wing center
section, locate the center of the wing center section and
draw a line 3" long marking the center of the wing.
9. Place the plywood wing bolt plate on the bottom of the
wing center section at the trailing edge of the wing, aligning
the lines that you drew on the wing and the wing bolt plate.
Trace the plywood landing gear plate onto the center of the
wing with a marker. Cut away the covering inside of the lines
you have just traced onto the wing, being careful not to cut
into the wing sheeting.
10. Using 6-minute epoxy, glue the plywood wing bolt
plate to the wing center section in the area where you have
removed the covering.
11. Turn the wing over so that you are looking at the top
of the wing. Use a 17/64" [6.7mm] drill bit to drill through the
wing bolt holes into and through the landing gear plate.
7