- ページ 6

おもちゃ GREAT PLANES Spectra SelectのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Spectra Select 12 ページ。 Ready-to-fly 2-meter electric sailplane

4. Completely undo any antenna knot. Gently extend the

antenna and let it dangle freely out the end of the aft

fuselage. Connect the elevator clevis to the elevator control

horn at the 4th hole from the inside. Note: Never cut or

shorten the antenna wire.

Wing Dowel Installation

1. Install the wing dowels into the wing dowel holes as

shown. Be sure that the smaller dowel (7mm x 90mm)

should be installed into the aft holes. Note: The canopy was

removed in this image for clarity.

Turn the transmitter switch on. Install the motor battery in

the airplane under the speed control and connect it to the

receiver. Turn the receiver switch on. Mark the "ON" position

of the switch. Note: The position of the receiver switch and

safety button may vary slightly from what you see in the

above image.

Center the surfaces using the trims on your radio

transmitter. Use the sketch above to make sure the control

surfaces are moving in the correct directions.

The control throws are as follows:

Elevator

1/2" [13mm]

LEFT

Rudder

1-1/2" [38mm]

DOWN

1/2" [13mm]

RIGHT

1-1/2" [38mm]