GREAT PLANES Spectra Select 사용 설명서 - 페이지 6
{카테고리_이름} GREAT PLANES Spectra Select에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. GREAT PLANES Spectra Select 12 페이지. Ready-to-fly 2-meter electric sailplane
페이지 인쇄
4. Completely undo any antenna knot. Gently extend the
antenna and let it dangle freely out the end of the aft
fuselage. Connect the elevator clevis to the elevator control
horn at the 4th hole from the inside. Note: Never cut or
shorten the antenna wire.
Wing Dowel Installation
1. Install the wing dowels into the wing dowel holes as
shown. Be sure that the smaller dowel (7mm x 90mm)
should be installed into the aft holes. Note: The canopy was
removed in this image for clarity.
Radio Settings
Turn the transmitter switch on. Install the motor battery in
the airplane under the speed control and connect it to the
receiver. Turn the receiver switch on. Mark the "ON" position
of the switch. Note: The position of the receiver switch and
safety button may vary slightly from what you see in the
above image.
Center the surfaces using the trims on your radio
transmitter. Use the sketch above to make sure the control
surfaces are moving in the correct directions.
The control throws are as follows:
UP
Elevator
1/2" [13mm]
LEFT
Rudder
1-1/2" [38mm]
6
DOWN
1/2" [13mm]
RIGHT
1-1/2" [38mm]