- ページ 16

おもちゃ GREAT PLANES Spirit 100のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Spirit 100 20 ページ。

ページを印刷する

❏

5. Mount the 6-32 tow hook to the fuse with the 6-32 nut

to lock it in place.

Apply the Decals

1. Use scissors or a sharp hobby knife to cut the decals from

the sheet.

2. Be certain the model is clean and free from oily fingerprints

and dust. Prepare a dishpan or small bucket with a mixture of

liquid dish soap and warm water–about one teaspoon of

soap per gallon of water. Submerse the decal in the soap and

water and peel off the paper backing. NOTE: Even though

the decals have a "sticky-back" and are not the water transfer

type, submersing them in soap and water allows accurate

positioning and reduces air bubbles underneath.

3. Position decal on the model where desired. Holding the

decal down, use a paper towel to wipe most of the water away.

4. Use a piece of soft balsa or something similar to squeegee

remaining water from under the decal. Apply the rest of the

decals the same way.

GET THE MODEL READY TO FLY

Check the Control Directions

❏

1. Turn on the transmitter and receiver and center the

trims. If necessary, remove the servo arms from the servos

and reposition them so they are centered. Reinstall the

screws that hold on the servo arms.

❏

2. With the transmitter and receiver still on, check all the

control surfaces to see if they are centered. If necessary, adjust

the clevises on the pushrods to center the control surfaces.

4-CHANNEL RADIO SETUP

(STANDARD MODE 2)

4-CHANNEL

TRANSMITTER

ELEVATOR MOVES UP

4-CHANNEL

TRANSMITTER

RIGHT AILERON MOVES UP

LEFT AILERON MOVES DOWN

❏

3. Make certain that the control surfaces respond in the

correct direction as shown in the diagram. If any of the

controls respond in the wrong direction, use the servo

reversing in the transmitter to reverse the servos connected

to those controls. Be certain the control surfaces have

remained centered. Adjust if necessary.

Set the Control Throws

Use a Great Planes AccuThrow (or ruler) to accurately measure

and set the control throw of each control surface as indicated in

the chart that follows. If your radio does not have dual rates, we

recommend setting the throws at the high rate setting.

These are the recommended control surface throws:

High Rate

ELEVATOR:

5/8" [16mm] up

5/8" [16mm] down

RUDDER:

1-1/2" [38mm] right 1" [25mm] right

1-1/2" [38mm] left

AILERONS:

3/4" [19mm] up

3/4" [19mm] down

Full

FLAPS:

2" [50mm]

SPOILERS:

2-1/4" [57mm]

IMPORTANT: The Spirit 100 ARF has been extensively

flown and tested to arrive at the throws at which it flies

best. Flying your model at these throws will provide you

with the greatest chance for successful first flights. If, after

you have become accustomed to the way the Spirit 100

ARF flies, you would like to change the throws to suit your

taste, that is fine. However, too much control throw could

make the model difficult to control, so remember, "more is

not always better."

4-CHANNEL

TRANSMITTER

RUDDER MOVES RIGHT

4-CHANNEL

TRANSMITTER

FLAPS NEUTRAL

(STICK DOWN, FULL FLAPS)

Low Rate

1/2" [13mm] up

1/2" [13mm] down

1" [25mm] left

3/8" [9.5mm] up

3/8" [9.5mm] down

Half

1" [25mm]