- ページ 14

おもちゃ GREAT PLANES Super Sportster 40のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。GREAT PLANES Super Sportster 40 20 ページ。

tail gear assembly to the plate using two #2 x 1/2" sheet

metal screws.

❏

3. Slide the tail gear actuator onto the tail gear wire. Mark

the location of the actuator on the rudder and remove the

covering inside those marks. Use 6-minute epoxy to attach

the actuator to the rudder.

Radio Installation

❏

1. Mount the rudder, elevator and throttle servos in the fuselage.

Use the following sequence for mounting the servos into the

servo tray:

❏

A. Install rubber grommets and brass eyelets in the servos

using the provided sketch.

❏

B. Test fit the servos in the tray. Enlarge the openings if

needed to create a 1/32" [.8mm] gap around the servo.

❏

C. Mark servo mounting hole locations on the tray, then

drill 1/16" [1.5mm] pilot holes through each mark.

❏

D. Mount the servos with the screws provided with your

radio system.

❏

2. Install the rudder nylon control horn in line with the pushrod

exit. Hold the horn in position and mark the location of the

mounting holes. Drill 3/32" [2.5mm] mounting holes through

the marks. Wick two to three drops of thin CA into the holes

to harden the underlying balsa, and then re-drill the holes.

Attach the horn using two 2-56 x 5/8" machine screws and

a nylon nut plate. Do not overtighten the screws,

crushing the underlying balsa.

❏

3. Install the rudder pushrod. Place a clevis retainer onto a

clevis. Thread the clevis 14-turns onto the pushrod. Attach

the clevis to the outside hole on the control horn. Slightly

bend the pushrod as necessary to allow free movement.

❏

4. Center the rudder and rudder servo and mark the pushrod

where it crosses the servo arm. Enlarge the servo horn hole

with a 5/64" [2mm] drill bit. (The Hobbico Quick Drill set

(HCAR0699) works well for this purpose.)