マイクシステム Hiberr YU-E20のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Hiberr YU-E20 3 ページ。 Professional wireless microphone system
ページを印刷するSPECIFICATIONS
SYSTEM:
① Frequency preparation: PLL
② Frequency range: Optional (60 frequencies for selection )
③ AF Response:80Hz~15Khz(±3dB)
④ Distortion:≤1%
⑤ Operating Temperature Range: -10℃ ~+40℃
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
*Piece suddenly goes dead
The unit is dead
*No power supply
*Transmitter is not switched ON
No receiption
*Transmitter and receiver donot work though all
LEDs andconnections seem ok
The hand mic is
*2x1.5V battery inserted wrong
not working
*2x1.5V battery is weak
*Input Gain of the Amplifier orMixer very high
Distorted sound
*Gain on the hand mic is toohigh
*Transmission distance between the transmitter
No"RF" signal
andreceiver is very far
on the receiver
*Defective or broken antenna
*Transmitter and receiver have different frequencies
*Two transmitters using the same frequency
Noise / Distortion
interference from other transmitter
*Battery of the transmitter isweak
IMPORTANT NOTICE
·
Please kindly read and keep this manual carefully.
·
Take attention of the full items show on the manual.
·
Must cut off the power while cleaning the equipment.
·
It is better using the original accessories, such as adapter and cable.
·
While it is thunderstorm weather or don't use the equipment for a long
time, please unplug the receiver from equipment.
·
Do not place the receiver and transmitter near the source of heat, such as
radiator, oven and also keep them away from water.
contact details
WEB：www.hiberr.com
Facebook: https://www.facebook.com/hiberr.mic
E-Mail: [email protected]
RECEIVER :
① Sensitivity: 12dBμv(80dB S/N)
② Sensitivity adjust range: 12~32dBμv
③ Audio output level: 0~0.5V/600Ω
Audio output:0~0.5V/5k
TRANSMITTER :
① RF output power: 11mW (10mW~30mW)
② Spurious rejection:<-50dB
③ Battery: 2*1.5V AA (common)
2*1.2V AA(rechargeable)
①Cartridge: dynamic
SOLUTION
*Check the power supply
*Connect power adapter
*Switch ON the transmitter
*Make sure that the transmitter and receiver are on the same
frequency
*Receiving antennas are not pulled out, extend the antennas
*Reverse the Polarity
*Reverse the battery
*Reduce the gain in the Mixer or Amp and adjust the volume
control on the transmitter
*Reduce the gain in the Hand mic
*Reduce the distance betweentransmitter and receiver
*Check antenna and replace it if necessary
*Make sure the transmitter and receiver are of the same
frequency
*Switch off the other transmitters
*Avoid using two transmitter of the same frequency
*Replace the battery
CLEANING AND MAINTENANCE
·
Do not spill the liquid into the device, otherwise it will
damage the electronic components of the device.
·
Disconnect the power before cleaning
·
Clean the device with a soft cloth.
·
No solvent or cleaner is allowed for cleaning.
PROFESSIONAL WIRELESS
MICROPHONE SYSTEM
USER'S MANUAL
YU-E20
OPERATING INSTRUCTIONS
Please read the instruction manual carefully before
operating the appliance and keep the instruction manual properly.
IR
FREQ
CHAN
PILOT
UHF Professional Wireless Microphone System
UP
PRAK
CH
DOWN
40
0
25
-15
10
-25
SCAN/SYNC
5
-35
RF
AF
VOL/LOCK
MHZ
557.250
MHZ
FREQ
YU-E��
UP
PRAK
CH
DOWN
0
40
MH
MH
Z
Z
-15
25
-25
10
SCAN/SYNC
-35
5
AF
RF
VOL/LOCK
IR