Hiberr YU-E20 Manual do utilizador

Procurar online ou descarregar pdf Manual do utilizador para Sistema de microfone Hiberr YU-E20. Hiberr YU-E20 3 páginas. Professional wireless microphone system

Imprimir página

SPECIFICATIONS

SYSTEM:

① Frequency preparation: PLL

② Frequency range: Optional (60 frequencies for selection )

③ AF Response:80Hz~15Khz(±3dB)

④ Distortion:≤1%

⑤ Operating Temperature Range: -10℃ ~+40℃

TROUBLESHOOTING

PROBLEM

POSSIBLE CAUSE

*Piece suddenly goes dead

The unit is dead

*No power supply

*Transmitter is not switched ON

No receiption

*Transmitter and receiver donot work though all

LEDs andconnections seem ok

The hand mic is

*2x1.5V battery inserted wrong

not working

*2x1.5V battery is weak

*Input Gain of the Ampliﬁer orMixer very high

Distorted sound

*Gain on the hand mic is toohigh

*Transmission distance between the transmitter

No"RF" signal

andreceiver is very far

on the receiver

*Defective or broken antenna

*Transmitter and receiver have diﬀerent frequencies

*Two transmitters using the same frequency

Noise / Distortion

interference from other transmitter

*Battery of the transmitter isweak

IMPORTANT NOTICE

Please kindly read and keep this manual carefully.

Take attention of the full items show on the manual.

Must cut oﬀ the power while cleaning the equipment.

It is better using the original accessories, such as adapter and cable.

While it is thunderstorm weather or don't use the equipment for a long

time, please unplug the receiver from equipment.

Do not place the receiver and transmitter near the source of heat, such as

radiator, oven and also keep them away from water.

contact details

WEB：www.hiberr.com

Facebook: https://www.facebook.com/hiberr.mic

E-Mail: [email protected]

RECEIVER :

① Sensitivity: 12dBμv(80dB S/N)

② Sensitivity adjust range: 12~32dBμv

③ Audio output level: 0~0.5V/600Ω

Audio output:0~0.5V/5k

TRANSMITTER :

① RF output power: 11mW (10mW~30mW)

② Spurious rejection:<-50dB

③ Battery: 2*1.5V AA (common)

2*1.2V AA(rechargeable)

①Cartridge: dynamic

SOLUTION

*Check the power supply

*Connect power adapter

*Switch ON the transmitter

*Make sure that the transmitter and receiver are on the same

frequency

*Receiving antennas are not pulled out, extend the antennas

*Reverse the Polarity

*Reverse the battery

*Reduce the gain in the Mixer or Amp and adjust the volume

control on the transmitter

*Reduce the gain in the Hand mic

*Reduce the distance betweentransmitter and receiver

*Check antenna and replace it if necessary

*Make sure the transmitter and receiver are of the same

frequency

*Switch oﬀ the other transmitters

*Avoid using two transmitter of the same frequency

*Replace the battery

CLEANING AND MAINTENANCE

Do not spill the liquid into the device, otherwise it will

damage the electronic components of the device.

Disconnect the power before cleaning

Clean the device with a soft cloth.

No solvent or cleaner is allowed for cleaning.

PROFESSIONAL WIRELESS

MICROPHONE SYSTEM

USER'S MANUAL

YU-E20

OPERATING INSTRUCTIONS

Please read the instruction manual carefully before

operating the appliance and keep the instruction manual properly.

FREQ

CHAN

PILOT

UHF Professional Wireless Microphone System

PRAK

DOWN

-15

-25

SCAN/SYNC

-35

VOL/LOCK

MHZ

557.250

MHZ

FREQ

YU-E��

PRAK

DOWN

-15

-25

SCAN/SYNC

-35

VOL/LOCK