- ページ 7

電話 GAI-Tronics 1090のPDF インストールとユーザーマニュアルをオンラインで閲覧またはダウンロードできます。GAI-Tronics 1090 20 ページ。 Hands-free telephones vandal resistant (vr) and help point

cable entry hole and tighten, so that its sealing washer is compressed

against the enclosure surface.

4. Proceed with chosen mounting method below

5.2.1

1. Using a suitable tool, punch out the 4 holes in the rear enclosure,

taking care not to damage or dislodge the plastic bushes. Only four

of the eight holes are required - the outer ones are recommended.

The inner holes are provided to be compatible with older-style

mounting posts, and should be left intact if not used. If the inner

holes are used they must be fitted with the supplied plastic bushes.

WARNING:.An unsafe condition could occur (and your warranty will be

invalidated) if :-

1. Any fixing hole made in the rear enclosure is left unused.

2. Any additional holes are drilled into the telephone enclosure.

3. Plastic bushes are not used on all fixing holes.

2. Mark the wall with hole centres based on the dimensions shown

(145 x 270mm). If necessary offer the rear enclosure up to the wall

to check alignment. Do not use the enclosure as a template for

drilling.

3. Drill holes in the wall on the marked positions. Select appropriate

screws, wall plugs etc., for the type of wall, bearing in mind that the

weight of the complete phone is around 5kg.

IMPORTANT: USE ONLY countersunk-headed fixing screws. Check

that screws seat properly in the plastic bushes to ensure a

watertight seal. Do not use excessive tightening force, as this may

crack the case.

4. Ensure that all four plastic flanged bushes are in place and the rear

enclosure is screwed tightly to the surface to prevent any water

ingress through the punched holes.

5. Complete the installation by making the appropriate connections

(section 6) and re-fitting the face plate.

VR & Help Point

Wall mounting