- ページ 12
パワードライバー Greatneck 80122のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Greatneck 80122 17 ページ。 4.8 v cordless pivoting screwdriver
ページを印刷するCHARGING THE BATTERY
1.
Place the cordless screwdriver near a
120 V, 60 Hz electrical outlet.
2.
Insert the battery charger plug (1) into
the charger receptacle (2) in the
handle of the cordless screwdriver (3)
(Fig. 1).
3.
Plug the battery charger (4) into a
120 V 60 Hz wall receptacle.
NOTES:
a) The red indicator light (5) in the handle
will turn ON, indicating a positive
connection with the charger.
b) The red indicator light will remain ON
until the charger is disconnected.
c) A new battery or one that is completely
run down should be charged for 5 hours.
After normal use, a battery should be fully
charged in about 3 hours or more.
d) If the battery does not charge properly,
check to make sure the electrical outlet is
"live" and that the temperature range in the
work area is between 10–40°C (50–104°F).
Fig. 1
ASSEMBLY & OPERATION
INSTALLING SCREWDRIVER BITS
!
WARNING:
the cordless screwdriver near the switch
while changing screwdriver bits.
Accidentally touching the switch may
start the tool and possibly cause an
injury.
1.
Select an appropriate screwdriver bit
that fits the head of the screw being
driven.
NOTES:
a) Use the largest size screwdriver bit
that will properly fit the screw head.
b) Make sure the screwdriver bit is in
good condition and is neither damaged
nor worn.
2.
Insert the screwdriver bit (1) fully into
the screwdriver collet (2) (Fig. 2).
NOTES:
a) Make sure the screwdriver bit is fully
inserted into the collet.
b) If required, insert the magnetic hex
bit extension (3) into the collet first and
then insert the screwdriver bit fully into
the magnetic hex bit extension.
12
Never hold the body of
Fig. 2